1. Display the NICE main menu. (How to Activate NICE)
  2. Press "Next" on the NICE main menu screen.
  3. Press "Keystone regist: print".

  4. Select the tray for the registration adjustment, and then press "Select".

    • The adjustment is done for each tray.
    • Adjustment is available only for trays associated with the custom paper library. Trays used under manual settings are greyed out and cannot be adjusted for registration.
    • Pressing "Duplex" will switch to "Simplex". The default is set to "Duplex". Switch to "Simplex" for precise registration of the first side.

  5. Press "[Start] OK".
  6. The machine makes the following printouts.

    • [A] and [C]: Blank sheet (3 copies printed respectively before and after the test chart)
    • [B]: Test chart (3 sheets)

    The blank sheet (6 sheets) is not used for the adjustment.

  7. Press "[Start] OK".

    The waiting time is displayed on the screen. The waiting time differs depending on the paper thickness.

  8. Press "[Start] OK".
  9. Press "Next" on the NICE main menu screen.
  10. Press "Keystone regist: adjust".
  11. Press "[Start] OK".

  12. Attach the test chart [A] to the registration tool [B], so that the QR code [C] appears through the cut-out.

    Make sure that the edge of the test chart is inside the slit of the hook as shown below.

    • [A]: Bad
    • [B]: Good

  13. Place the chart [A] and the attached registration tool on the exposure glass so that the side printed with the bar code faces down.

    Make sure the top and left edges of the chart are set flush against the edges of the exposure glass.

  14. Press "[Start] OK" to start the scan.

    • If the required waiting time has not elapsed since the test charts were printed, the following message will appear. Precise adjustment results may not be obtained if you do not wait for 10 minutes.
    • The waiting time for the precise adjustment results differs depending on the paper thickness.

  15. After the scan is completed, remove the chart from the exposure glass. Then press "[Start] OK" on the following screen. Do the same for the 2 other charts.

    • If the chart was scanned incorrectly as in the following list, an error message will appear.
      • The same chart was scanned.
      • The QR code was not scanned.
      • The chart was not placed correctly on the exposure glass.

    • If the error message appears, press "[Start] Retry" and scan again to recover from the error.

  16. Press "[Start] OK" after scanning all three charts to confirm that the adjustments were made.
  17. Press "[Start] OK" to finish.
  18. Turn OFF the machine power and remove the NICE SD card from the service card slot.