1. Look at the ferrite cores on the antenna cables.
    • Antenna 1 [A]: The core on the Antenna 1 cable is black.
    • Antenna 2 [B]: The core on the Antenna 2 cable is white.


  2. Attach the Velcro fastener [B] to the antenna [A].

    • The fastener should be attached to the cable side.

  3. Peel off the double-sided tapes on the Velcro fastener, and attach Antenna 1 [A] (having a black ferrite core) to the rear middle of the machine.

  4. Peel off the double-sided tapes on the Velcro fastener, and attach Antenna 2 [B] (having a white ferrite core) to the rear right of the machine.

    • [A] has to be kept 12 cm away from [B].

  5. Attach the eight clamps as shown below.

  6. Set the cables of Antenna 1 and Antenna 2 in the 8 clamps and close them.

    • Make sure that the cables are not slack. Keep them wired tightly along the covers.

  7. Turn ON the main machine.

  8. Make sure that the machine can recognize the option: User Tools > Machine Features > Printer Features > List/Test Print > Configuration Page.

You may have to move the machine if the reception is not clear.

  • Make sure that the machine is not located near an appliance or any type of equipment that generates strong magnetic fields.
  • Put the machine as close as possible to the access point.