The rail must be standing on the floor. If the screw holes on the LCIT are too high or too low, and do not overlap the vertical screw slots in the rail, the rubber feet of the rail must be adjusted. Change the rubber foot positions on the rail before installing the rail.

  1. The rubber feet are placed at [A] as shown below.
  2. The slotted screw holes in the rail for attaching the rail to the LCIT have a tolerance for the height (-/+ 2 mm). If you can move the rail up or down within this -/+ 2 mm tolerance so that it is installed correctly, with the feet on the floor, you do not need to do the following steps.
  3. If you cannot install the rail within the -/+ 2 mm height tolerance, change the rubber foot position to adjust the height of the rail.
    • If the screw holes of the machine are above the slotted holes of the rail, change the rubber foot position as shown below.
    • If the screw holes of the machine are below the slotted holes of the rail, change the rubber foot position as shown below.

When changing the rubber foot position, remove the rail bracket [A]. After changing the rubber foot position, reinstall the rail bracket.