Removing Spacers

  1. Enter the SP mode and set SP1-206-001 to "2" (Off).
  2. Disconnect the peripheral unit from the upstream device.
  3. Remove the spacers from the peripheral unit where the problem occurred.
    The photos below show where you can find the spacers for each unit.
    Multi-folding Unit

    Booklet Finisher, Finisher

Inserting Spacers

  1. Loosen the screws of the connecting bracket attached to the peripheral upstream of the unit where the problem occurred.
  2. Insert a spacer and tighten the screws.
    If the trailing edge is skewing toward the front of the machine, insert a spacer [B] under the rear end of the bracket and tighten the screws.
    -or-
    If the trailing edge is skewing toward the rear of the machine, insert a spacer [A] under the front end of the bracket and tighten the screws.
  3. Do another run to check the adjustment. If skew is still present, insert another spacer.
    • Each spacer is 2 mm thick.
    • Only two spacers are provided, so the maximum adjustment is 4 mm (using two spacers).
  4. Enter the SP mode and re-set SP1-206-001 to "1".