Turn OFF the machine and disconnect the machine power cord before you do this procedure.

  1. Remove all tape and retainers from the LCIT.
  2. Open the front door [A] and paper tray unit [B], and remove all tape and retainers from the LCIT.

  3. Open the vertical transport door [A] and remove the LCIT cover [B].
  4. Remove the cover [A].

  5. Install the stay [A] on the main machine. (M4 x 8)

    • Set the embossed side of the stay against the main machine.

  6. Remove the connector cover [A] and LCIT connecting cover [B].
  7. Install the upper positioning pins [A] and [B].
  8. Install the lower positioning pin [A].
  9. Remove the grounding plate [A].
  10. Change the orientation of the grounding plate, and then install it as shown below.
  11. Open the front cover [A].
  12. Remove the screw [B] and release the lock plate [C]. (M4 x 8)
  13. Remove the rear lower cover [A].
  14. Remove the cut-out part [A].
  15. Fix the heater bracket [A].
  16. Connect the connection cable [A] and fix the grounding wire [B].
    To fix the grounding wire, remove the screw and replace it with the polished round screw M3.
  17. Reattach the rear lower cover to the main machine.

  18. Install the LCIT [B] on the main machine [A].
  19. Reattach the left corner plate [A]. (M4 x 8)

  20. Set the leveling shoes [A] (front left, front right, rear left, rear right side of the LCIT).

    • Align the bottom of the machine paper tray and the bottom of the LCIT front cover [B].
    • Adjust the level of the LCIT top surface [C] until it is within ±2.5/1000mm.

  21. Remove the rear middle cover [A] by moving it upward.
  22. Connect the LCIT interface cable [A] to the LCIT connector of the main machine.

  23. Open the bypass tray unit [A].

      • Push down the lever [A] when opening the bypass unit.

  24. Prepare the caution decal [A] provided with the LCIT. (Accessories No.9, Decal: misfeed removal: manual feed: 250)
  25. Attach the caution decal to [A] on the bypass tray unit.
    • [B]: 2mm
    • [C]: 2mm
  26. Prepare the sponge decal [A] provided with the LCIT. (Accessories No.8, Decal: transport: cover)

  27. Attach the sponge decal to [A] on the exit cover.

      • Attach the sponge decal [A] on the corner of the exit cover.
        • [B]: 50 mm
        • [C]: 65 mm

  28. Prepare the Decal: caution chart: paper set direction [A].

  29. Draw out the paper tray and attach the decal [A] on the top of the front door.
    Select one of the decals according to the paper that will be used by the customer.

    • Paper type, brand, etc. can be written on the blank space.

  30. Attach a decal to the front door.

    Pro C5210S/C5200S: Attach the Decal: LED supplied with the LCIT.
    MP C8003/C6503: Attach a blank sheet on the paper size decal supplied with the main machine.
  31. Plug in the machine and turn it ON.