When unpacking the machine, the ITB separation lever is not yet attached to the correct location. Be sure to attach the lever when installing the machine.

After transporting the machine, the load on the front part of the machine may cause the drawer unit to become stuck, making it impossible to draw it out.

[A] (Normal): When the drawer unit is pulled, the lock mechanism is lifted and the drawer unit is unlocked.

[B] (Abnormal): The drawer unit is stuck.

If this happens, push the drawer unit in and try pulling it out again.

Also, please note that when the power is turned ON, the drawer unit will be pulled in automatically, and this will solve the problem.

  1. Open the toner supply unit front cover [A], and remove the ITB separation lever [B].
  2. Open the drawer unit [A].
  3. Remove the drawer unit cover [A].

    Note: TCRU screws

  4. Close the drawer unit.

      • Pushing the drawer unit back into the machine allows you to close the guide plate [A] of the paper exit and duplex unit after removing the drawer unit cover.
      • Make sure to hold down the lock lever [A] when pulling out the drawer unit. The drawer unit is locked in place by this lever.

  5. Remove the ITB cleaning intake fan [A] along with the duct.

    Note: TCRU screws

  6. Open the toner supply unit front cover [A].

    Remove the fixing screws of the toner supply unit [A].

    Note: TCRU screws

    Do not remove the screw [B] below the toner supply unit fixing screw [A] because it is used to fix the faceplate.

  7. Slide the toner supply unit [A] to the front.
  8. Attach the ITB separation lever [A] horizontally from the right side of the machine.
  9. Turn the ITB separation lever [A] clockwise until it stops.
  10. Return the toner supply unit to the machine and secure it with the screws.
  11. Attach the ITB cleaning intake fan and drawer unit cover