1. Remove the drawer unit cover. (Drawer Unit Cover)
  2. In order to facilitate the work, press the release lever to fully open the drawer unit [A].
  3. Remove the connectors and clamps to remove the drawer unit lock motor cover [A].
  4. Remove the drawer unit lock motor cover [A].

  5. Remove the registration motor [A] along with the bracket.

    • When installing the motor, attach the timing belt.

  6. Remove the timing pulley [A].
  7. Remove the positioning bracket [A].
  8. Remove the fixing screws of the registration adjustment bracket [A].

  9. Move the registration unit [A] to the left and lift it, then remove the registration adjustment bracket [B].

  10. Remove the registration unit [A].
After re-installing the registration unit:

  1. Adjust the dial of the registration adjustment bracket [B] to the factory set position.

    The factory set position is marked with a black* line [C] as shown below.

    *The color is subject to change.

     

  2. Print copies of the test pattern Trimming Area (SP2-109-003).
    If the trim position is not correct, adjust the skew.
    The range of adjustment is ±1 on the dial against the black mark [C] (See step 1).
    • If the width of [1] is less than [2] in the paper feed direction, adjust the position of the adjustment bracket in the [+] direction.
    • If the width of [1] is more than [2] in the paper feed direction, adjust the position of the adjustment bracket in the [-] direction.