• Turn the machine off and disconnect the machine power cord before you start this procedure.

  1. Remove the filament tape [A].

    • Move the mail box carefully. It is easy to cause damage to the corner leaf plate [B].

  2. If the Cover Interposer Tray CI4040 is installed on the Finisher SR4120 or Booklet Finisher SR4130, remove it.

    • The Cover Interposer Tray CI4040 and mail box cannot be installed on the finisher at the same time.

  3. Remove the finisher from the main machine.
    • Disconnect the finisher connector [A] from the machine.
    • Open the front door [A] of the finisher, and pull the lock lever [B].
    • Remove the finisher from the main machine.

  4. Remove the top cover [A] from the finisher.

    Be careful that the guide plates and other parts inside the finisher do not become deformed.


  5. Install the finisher on the main machine.
    • Slowly push the finisher against the left side of the machine, keeping its front door open until the brackets go into their slots.
    • Push the lock lever [A], and then secure it.
    • Connect the finisher connector [A] to the machine.
  6. Attach the guide plate [A] to the top of the finisher.
  7. Attach the mail box [A] to the top of the finisher (M3 x 8).
  8. Attach the 9 trays [B] to the mail box.
  9. Give the decals [C] to the customer. The customer will write on these and attach them at the correct location.

  10. Turn ON the main power switch of the machine.
  11. Check the operation.