1. Remove the rear cover [A].
  2. Confirm that the connectors [B] are free.
  3. Place the tray unit [C] on top of the cover interposer transport unit.
  4. Attach the knob screw [D].
  5. Connect the harness connectors [E].
  6. Reattach the rear cover.
  7. Remove the front inner cover [A] from the dual-tray unit.
  8. Fasten the tray unit to the top of the transport unit with the knob screws [B] (M4x8).
  9. Attach the base cover [A]. (M4x10)
  10. Confirm that the holes in the cover match the positions of the reference pins.
  11. Re-attach the front inner cover [B] (removed at step 7 above).
  12. Position the tray unit front door [C] so that its hinges match the posts on the frame of the tray unit.
  13. Hold the lower L-pin [D] as shown, insert it halfway, push it up, then rotate it into its groove.
  14. Hold the upper L-pin [E] as shown, insert it halfway, push it down, then rotate it into its groove.
  15. Attach the spacer [A] to the rear of the transport unit. (M4x12)
  16. Set the leveling shoes [A] (x4) under the feet.
  17. Turn the nuts to adjust the height of the cover interposer until it is level.