When installing the main machine, make the machine level.

  • If the machine is not leveled, the tilt of the machine reduces the accuracy in side-to-side registration.
  • The front and rear side of the machine must be less than 5 mm (0.2") away from level.

  1. Place the four leveling shoes [A] below the bolts [B] under each corner of the machine.

  2. Turn the nuts [B] to lower the bolt until the bolts reach the leveling shoes [A].

    Example below: Front side

    • Use a wrench to raise or lower the nuts.

  3. Open the ADF, and then place a level [A] on the exposure glass.

  4. Adjust the machine level until the machine is less than 5mm from level (measure from left-to-right).

    • When the right side of the machine is lower: Lower the nuts of the right side of the machine (front and rear) to lift the right side of the machine.

    • When the left side of the machine is lower: Lower the nuts of the left side of the machine (front and rear) to lift the left side of the machine.

  5. Open the ADF, and then place the level [A] along the side.

  6. Adjust the machine level until the machine is less than 5mm from level (measure from front-to-rear).

    • When the front side of the machine is lower: Lower the nuts of the front side of the machine (left and right) to lift the front of the machine.

    • When the rear side of the machine is lower: Lower the nuts of the rear side of the machine (left and right) to lift the rear of the machine.