1. On top of the finisher, remove the connector cover [A].

  2. Remove metal cover [B].

  3. On the right rear inside panel of the finisher [A], fasten one shoulder screw.
  4. On the right front post of the finisher [A], fasten the other shoulder screw.
  5. To avoid damaging the guides [A] on the right side of the unit, elevate the unit with some blocks, boxes, etc. [B] so it is not flat on the floor.
  6. Select the rear tray mounting bracket [A], and then locate its screw holes between the keyholes on the rear frame.
  7. Align the holes, and then fasten the tray mounting bracket to the frame.
  8. Fasten the other mounting bracket to the front frame at [A] and [B].

  9. If the upstream device is the main machine or "Multi-Folding Unit FD4000", proceed to step 10. If the upstream device is any other option, replace the original guide plate [A] with "GUIDE PLATE: CONNECTING: LOWER" (item #19 of the accessories).

    • With the original guide plate installed, lever [A] will catch the optional device if released for jam recovery.

    1) Release the lever [A].

    2) Remove the entrance guide plate [A].

    The original guide plate will no longer be used and does not have to be stored.
    3) Attach the new entrance guide plate [A] (item #19 of the accessories) to the frame of the cover interposer.

    4) Lift up the lever to its home position.

  10. If the upstream device is the main machine, attach the guide sheet provided with the main machine. If the upstream device is not the main machine, proceed to step 11.
    1) Prepare the guide sheet [A] provided with the main machine.

    2) Remove the release paper from the guide sheet [A], and attach the guide sheet to the bottom side of the upper entrance guide plate [B].

    [C]: Align the edge of the guide sheet with the edge of the upper entrance guide plate.
    [D]: Align the edge of the adhesive tape with the edge of the upper entrance guide plate.

  11. On the right side of the finisher, hold the tray unit over the finisher, and then align the hooks of the mounting brackets with the installed shoulder screws in the finisher.

  12. Slowly, lower the tray unit hooks onto the shoulder screws inside the finisher.

    • The shoulder screws are located on the front panel [A] and rear panel [B] inside the finisher.

  13. Look inside the finisher to confirm that the hook of the rear bracket is seated correctly on the shoulder screw.

  14. Fasten one screw below the Q2 lever to fasten the tray to the frame.

  15. Raise Q2.

  16. Fasten one screw to fasten the tray to the frame at the rear.