- Always switch the machine off and unplug the machine before doing the following procedure.
- Remove all tape and retainers from the LCIT.
- Open the vertical transport door [A] and remove the LCIT cover [B].
- Remove the cover [A].
- Install the stay [A] on the main machine. (M3 x 6)
- Remove the connector cover [A] from the main machine.
Install the rail [A] on the right side of the main machine. (M4 x 14)
- The rail must be standing on the floor. If the screw holes on the LCIT are too high or too low, and do not overlap the vertical screw slots in the rail, the rubber feet of the rail must be adjusted. (Adjustment for the Rubber Foot Positions on the Rail)
- Set the LCIT [A] on the rail [B], and then slide it towards the main machine.
- Install the LCIT on the main machine.
- Open the top right cover [A].
- Remove the right cover [A].
Fasten the rail to the LCIT. (shoulder screws)
- When you fasten the rail to the LCIT, the screw holes [B] of the rail need to be in the same position as the screw holes [A] of the LCIT.
- When you fasten the rail to the LCIT, the screw holes [B] of the rail need to be in the same position as the screw holes [A] of the LCIT.
- Reattach the right cover, and then connect the plug [A] of the LCIT power connector to the side of the machine.
- Prepare the Decal: caution chart: paper set direction [A].
Open the top right cover and attach the decal as shown below.
Select one of the decals according to the paper that will be used by the customer.- Paper type, brand, etc can be written on the blank space.
- Attach a decal to the front.
Pro C5210S/C5200S: Attach the Decal: LED supplied with the LCIT.
MP C8003/C6503: Attach a blank sheet on the paper size decal supplied with the main machine. Plug in the machine and turn it on.
- To move down the paper tray, cover the photo sensor with your left hand and press the bottom plate operation button [A].
- To move down the paper tray, cover the photo sensor with your left hand and press the bottom plate operation button [A].