Set two screws in the bottom half of the finisher front door [A].
Do not tighten these screws [B].
Set two screws in the top half of the finisher front door [A].
Do not tighten these screws [B].
Select the front door bottom extension.
Set the keyholes of the hinges [1] over the heads of the screws, and then slide the extension [2] down so that the heads of the screws slide into the cutouts.
Tighten both screws.
Select the front door top extension.
Set the keyholes of the hinges [1] over the heads of the screws, and then slide the extension [2] down so that the heads of the screws slide into the cutouts.
Check the top of the door and the top of the extension.
- If the top the door is not level with the top of the extension [A], slide the extension up slightly.
- Tighten the screws.
Attach the rear cover extension [A].
Remove the grounding plate [A] from the bottom right edge of the finisher.
Set the tab [1] and boss [2] of the grounding plate extension on the bottom edge, and then fasten it with the screws.
Hook the grounding plate onto the right edge of the extension.
Fasten the grounding plate to the extension.
At the right front corner of the finisher [A], peel off the tape.
Set one screw [B]. Do not tighten it.
Select the right front corner plate (the smaller plate).
Attach it to the right edge [A], and then lower its cutout over the set screw.
Use a long screwdriver inserted through the hole at [C] to tighten the screw and fasten the plate.
At the right rear corner of the finisher [A], peel off the tape.
Set two screws [B]. Do not tighten them.
When you attach the plate [C], hook the cutouts under the plate over the set screws.
Use a long screwdriver inserted through the cutouts under the plate [A] to tighten the screws and fasten the plate.