• Turn the machine off and disconnect the machine power cord before you do this procedure.

  1. Unplug the machine power cord before starting the following procedure.
  2. Unpack the finisher and remove all tapes and shipping retainers.
  3. Open the front door and remove the shipping retainers.
  4. Remove the brackets, tags, and wires in this order: [A] > [B] > [C].
  5. Be sure to remove the two sheets of paper [D].
  6. If the upstream device is the main machine, prepare the guide sheet [A] provided with the main machine.
    If the upstream device is not the main machine, proceed to step 10.
  7. Divide the entrance guide plate [A] into two parts.
  8. Remove the release paper from the guide sheet [A], and attach the guide sheet to the side of the upper entrance guide plate [B] which becomes the inner side when assembled.

    [C]: Align the edge of the guide sheet with the edge of the upper entrance guide plate.
    [D]: Align the edge of the adhesive tape with the edge of the upper entrance guide plate.
  9. Reassemble the entrance guide plate [A].
  10. Install the grounding plate [A]. (M3 x 6)
    Set the grounding plate so that there is no gap between the plate and the bottom frame of the finisher (as shown).
  11. Install the table extension [B]. (M4 x 8)
    The edge of the table extension should be aligned with the edge of the finisher.
  12. Attach the cushion [C] to the right side of the upper cover.
  13. Install the entrance guide plate [D]. (M3 x 6)
  14. Insert the shift tray [A] into the grooves and fasten it. (M3 x 8)