Installation

Disconnect the finisher from the main frame.

Remove the rear cover.

Remove the shift tray.

Push the paper guides to the center.

Remove the rear paper guide cover.

Remove the front paper guide cover.

Disconnect the main paper guide cover.

Carefully, separate the front tabs at [A], and then remove the main paper guide cover [B].

Disconnect the cover installation bracket.

Slowly, disconnect the bracket from the rail above, and then remove it.

At the rear, set one shoulder screw [A].

At the front, set the other shoulder screw [A].

Spread the paper guides to the maximum width.

Move the jogger arms on the jogger unit to the center.

Hold the jogger unit so that the hooks [A] on both ends of the unit are in line with the installed shoulder screws [B].

Rotate the jogger unit slightly up under the output tray so that the motors on both ends of the unit go under the tray, and then hang the hooks on the shoulder screws at the front and rear.

Confirm that the rear bracket [A] is on the shoulder screw.

Confirm that the rear motor [B] is up under the tray.

Confirm that the front bracket [A] is on the shoulder screw.

Confirm that the front motor [B] is up under the tray.

Fasten the jogger unit at the rear [A] and front [B].

Connect the jogger unit at the rear.

Peel the back off the two accessory cushions.

Attach the cushions to the front [A] and rear [B] of the lower arms of the output tray.

Set the front end cover [A]. Do not attach the screw yet.

Set the rear end cover [A], and then fasten it [B].

Look at the jogger cover. Note the tabs and slots on the rear end [A], center arm covers [B], and front end [C].

Slowly, set the jogger cover [A] on the jogger unit.

At the rear [A], confirm that the tab inserts correctly.

At the front [B], confirm that both tabs set correctly.

In the center under the jogger unit, make sure the rear arm cover [A] and front arm cover [B] fit over the edge of the plate as shown.

After making sure that all tabs are set correctly, fasten the cover to the jogger unit.

Re-install the shift tray.

Check the center of the shift tray.
If the jogger arms are touching the surface of the shift tray as shown, this will cause a jam when the machine is turned on because the arms will move and hit the tray.

To avoid a jam at power on, before you turn the machine on you can:
Raise the jogger arms [A] slightly so that they are not touching the shift tray below.
-or-
You can spread the jogger arms [B] away from the center so that they are not touching the surface of the tray.