A spacer for correcting paper skew is attached to the bottom right of the finisher.

[A] Spacer for skew correction and side-to-side registration adjustment

  1. Check to see if the paper is skewed when it is exited from the machine.

  2. If skew correction is required, dock the finisher to the copier using the M4x20 screws included with the finisher.

    • This is because the M4x14 screws will not be long enough when the spacer(s) are attached.

    • When you attach the bracket, attach the spacer(s) as follows:
      • If the leading edge is skewed about 2mm toward the front (operator) side of the machine, attach a 2mm spacer to the rear side of the connecting bracket.
      • If the leading edge is skewed about 2mm toward the rear (non-operator) side of the machine, attach a 2mm spacer to the front side of the connecting bracket.


    [A]: Joint Bracket
    [B]: Spacer
    [C]: Finisher side
    [D]: Main machine (Mainframe) side
    [E]: Adjustable direction

    [A]: Screws (with spacer(s): M4 x 20, without spacer(s): M4 x 14)
    [B]: Joint Bracket
    [C]: Without spacer
    [D]: With 1-2 spacers
    [E]: Exterior Cover

  3. If skew correction is NOT required, dock the finisher to the copier using the M4x14 screws included with the finisher.

    • This is because without the spacer, the M4x20 screws are too long and the bracket cannot be fastened in place.


    [A]: Folding Unit
    [B]: Joint Bracket
    [C]: Screw (M4 x 20)
    [D}: Screw is too long and cannot be fully inserted