For SR3220/SR3210

Side-to-side registration can be adjusted by the docking bracket for SR3220/SR3210 [A] (and the docking bracket screw [B]).

1. Eject a sheet of A4(LEF) or A3 paper to the proof tray and check how many divisions of the scale the edge of the paper has shifted from the center.
   
   [A]: Scale marks for DLT
   [B]: Scale marks for A3
   [C]: 7 scale marks in 2mm intervals
   [D]: Center mark
2. Change the position of the standard bracket by rotating it 180 degrees as shown below. This makes the docking bracket easier to slide horizontally. Then reattach the docking bracket to the mainframe.
   
   [A]: Reverse

If paper shifts toward the front

Slide the docking bracket backward by the amount which corresponds to that of the shift, in order to move the finisher in the same direction.

e.g.: When paper has shifted by 4 mm from the center toward the rear (2 mm/division of the scale), move the docking bracket backward by 4 mm (2 divisions).

[A]: Proof Tray

[B]: Docking Bracket Screw

If paper shifts toward the rear

Slide the docking bracket backward by the amount which corresponds to that of the shift, in order to move the finisher in the same direction.

e.g.: When paper has shifted by 4mm from the center toward the rear (2 mm/division of the scale), move the docking bracket backward by 4 mm (2 divisions).

[A]: Proof Tray

[B]: Docking Bracket Screw