• SD card can be inserted with the machine power off.
  • During the updating process, do not turn off the power.
  • If you turn off the power during the updating, the machine performance is not guaranteed. (There is a possibility that an SC and boot failure occurs.)
  • If you accidentally turn off the power during the updating, retry the updating procedure from the beginning. (If the update fails again, you will need to replace the controller board.)

  1. If the boot priority application is set to the ESA application, switch to the copy application. ([System Settings]-[General Features]-[Function Priority])
  2. Take a note of the current Heap size. ([Extended Feature Settings] – [Administrator Tools] – [Heap/Stack Size Settings])
  3. Turn OFF the main power.
  4. Insert the SD card you created into the service slot, and then turn ON the main power switch.
  5. After booting Java VM, update of the application is started. "Updating SDK/J" appears in the banner message of the touch panel display. (Estimated time: about 2 minutes)
  6. After completing the update and starting the Java VM, "Update SDK / J done SUCCESS" will appear in the banner message of the touch panel display. After turning off the power, remove the SD card from the slot.
    When you fail to update, "Update SDK/J done FAIL" is displayed. You can confirm the cause of the error message below.
  7. Turn ON the main power.
  8. Check the Heap size is set to the value that you noted in step 2. ([Extended Feature Settings]-[Administrator Tools]-[Heap/Stack Size Settings]).
  9. Return to the previous setting for the boot priority application.