• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  • Before installing this option, attach the “Bridge Unit BU3070 (D685)” or "Internal Multi-Fold Unit FD3000 (D3E4)"first.
  • Attach the “LCIT PB3170/ PB3230 (D695)” or “Paper Feed Unit PB3210/PB3220 (D787)” first before installing this option.
  • This finisher is light and has a high center of gravity, so it easily topples when installing or moving it. Therefore, it is equipped with the stabilizer [A] attached to it when shipped.

  • When you lift the finisher at the time of unpacking, do not hold the part [A]. Doing so may damage the frame.

 

  1. After unpacking, immediately attach the stabilizer [B] to prevent toppling.
    Attach it along the guide rail [A] and push it in all the way, until it clicks.
  2. Remove the external orange tape and shipping retainers.
  3. Open the front cover, and then remove the filament tape and packing materials.
  4. Remove the fixing bracket [A].
  5. Pull out the saddle stitch unit [A], and remove the filament tape and packing materials.
  6. Remove the accessories in the package (fixing screws, etc.).
  7. Attach the shift tray [A] (x1; M4 x 8).
  8. Attach the booklet tray [A].
  9. Attach the entrance guide plate [A]. (M3×6)



  10. Clean the right side of the upper cover with a cloth moistened with alcohol, and then attach the cushion to the finisher.

    • Make sure that the cushion is aligned with the left-upper edge [A] of the upper cover.

      If the internal multi-fold unit is installed on the main machine, the cushion is too long. So cut off a section of the cushion at the notch in the cushion, so that the cushion does not interfere with the I/F connector [A] of the finisher.

       

  11. Attach the ground plate [A] (M3x6).


  12. Attach the joint bracket [A] to the machine (4x12).
    Tighten the joint bracket [A] and bracket [B] of the bridge unit together.

    If the machine is equipped with the internal multi-fold unit, attach the joint bracket [A] only.

    • Attach the screw so that the screw head is at the center of the mark.

  13. If the internal multi-fold unit is installed, connect the finisher cable to the connector on the internal multi-fold unit.
  14. Remove the screw on the connection lever [A] and pull the lever.
  15. Connect the finisher to the main unit, and then push in the connection lever [A] to fasten it to the main unit. (x1)

    When the Internal Multi-Fold Unit is installed, check that the two cables of the finisher do not cross each other, before connecting the finisher.
  16. Connect the interface cable [A] to the machine (only when the bridge unit is installed).
  17. Close the front cover.
  18. Turn ON the main power.
  19. Deliver some A3/DLT paper to the proof tray and check if the vertical registration is correct according to the adjustment scale for A3/DLT paper. (Finisher Registration Adjustment)
  20. Check that the finisher can be selected on the operation panel, and check the finisher’s operation.