1. When unpacking, hold both sides of the SPDF and take it out of the box.
  2. Place the unit on the machine temporarily, and remove the orange tapes and shipping retainers.
  3. Remove the accessories in the package (boards, fixing screws, etc.).
  4. Attach the 2 stepped screws to the machine.
  5. Align the hinges of the SPDF with the stepped screws, and attach them by sliding them in.
  6. Fix the SPDF to the machine (coin screws×2)
  7. Release the lever [A], then open the pressure plate sheet [B], and gently remove the protective sheet [C].
  8. Remove the filament tape, and shut the pressure plate sheet.
  9. Remove the platen sheet [A], and set it on the exposure glass.
    Align it with the left scale and rear scale of the printer.
  10. Close the SPDF slowly, and attach the platen sheet and SPDF.
  11. Remove the rear cover [A].
  12. Remove the controller box cover [A].
    Red Circle: Remove, Blue Circle: Loosen
  13. Connect the SPDF cable as shown and mount the brackets [A] and [B] on the machine’s rear frame.
    Make sure to connect the grounding wire.
  14. Connect the scanner cable to the connector at the machine’s rear.
  15. Attach the scanner cable with the bracket [A] to the inside of the controller box.
  16. Connect the cable to the IPU (CN531).
  17. Attach the supplied ferrite core (L) [A] and ferrite core (S) [B].
    Attach [A] close to the connector.
    Attach [B] near the end of the tube.
  18. Reattach the controller box cover and the rear cover.
  19. Attach the decals [A] and [B] to the SPDF.
  20. Attach the decal [A] to the scanner front cover.