• The machine should be held at the correct locations and lifted gently.
  • If it is lifted without care, handled carelessly or dropped, it may result in an injury.
  • When installing this option, turn the machine power OFF, and unplug the power supply cord from the wall socket.
  • If this option is installed with the power on, it may result in an electric shock or a malfunction.
  • Be sure to join the machine to the paper feed unit so as to prevent equipment from falling over.
  • If they are not connected, they may move and fall over, resulting in injury.

  1. Remove the orange tape and retainers.
  2. Remove the items provided (fixing screws, etc.) from the package.

  3. Holding the grips on the machine, align it with the locating pins [A], and place the machine on the paper feed unit.

    • When you lift the machine, be sure to hold the grips on the machine.
    • In particular, do not lift the machine by holding the scanner unit, etc., because this may cause the machine to deform.
    • Do not put the machine down on the paper feed unit as a temporary resting place. This may cause the paper feed unit to deform. Always connect the machine and paper feed unit properly.

  4. Pull out the 2nd paper feed tray of the machine.
  5. Using a securing bracket as a screwdriver, secure the machine to the LCT unit (hexagonal bolt: M4×8: 1).

  6. Attach the securing brackets [A] to two positions on the left and right at the rear of the machine.

    • If the anti-condensation heater for this optional tray is to be installed, connect its heater harness prior to this step (step 6) (Tray Heater for LCIT PB3170/ PB3230).
    • If “LCIT RT3030” is to be installed, connect its harness prior to this step (step 6) (LCIT RT3030 (D696)).


  7. Attach the rear lower gap cover [A] (x2)
  8. Return the paper feed tray to the machine.

  9. Attach the decals as shown below.

    [A]: Tray number decal
    [B]: Paper size decal

    • The tray number decal and paper size decal are packaged together with the machine.

  10. Lock the casters of the paper feed unit.

  11. Connect the power cord to the machine.

    • Stabilizers are attached to the LCIT when it is shipped. Do not remove any of them.

  12. Turn the power switch ON.
  13. Set the paper, and check that the paper size set in the paper feed tray is displayed on the operation panel.

  14. Adjust the registration for the paper feed unit.
    SP1-001-0xx (Leading Edge Registration Tray 3)

    -055

    Tray3: Thin

    -062

    Tray3: Thin:1200

    -056

    Tray3: Plain

    -063

    Tray3: Plain:1200

    -057

    Tray3: Mid-thick

    -064

    Tray3: Mid-thick:1200

    -058

    Tray3: Thick 1

    -065

    Tray3: Thick 1:1200

    -059

    Tray3: Thick 2

    -066

    Tray3: Thick 2:1200

    -060

    Tray3: Thick 3

    -067

    Tray3: Thick 3:1200

    -061

    Tray3: Thick 4

    -068

    Tray3: Thick 4:1200

    SP1-002-004 (Side-to-Side Registration Paper Tray 3)