• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  1. Open the right cover, and then remove the upper front cover [A].

    • When removing the upper front cover, release the hooks at the back of the cover.
    • Tilt the operation panel [B] upward to a horizontal position, and then remove the upper front cover [A].

  2. Remove the upper cover [A] of the upper front cover.
  3. Attach the corner cover [A] provided with this option.
    Use the screws removed in the previous step.
  4. Remove the scanner right cover [A].

  5. Pass the USB cable [A] through the hole.

    • This cable is not included in this unit. The user may need to provide it.

  6. Route the cable [A] to the back of the cover.
  7. Attach the upper front cover [A].
  8. Attach the spacer [A].

  9. Attach the sponge [A].

  10. Connect the cable to the IC reader [A] and attach the reader to the table.

    • This IC reader is not included in this unit. The user may need to provide it.

  11. Attach the reader cover [A].

    • Do not sandwich the USB cable with this cover.
    • Make sure that the reading area on the IC card reader is in contact with the IC card cover. If they do not contact each other, put the sponge(s) provided with the accessories underneath the IC card reader to fill the gap. Otherwise, the IC card reader will not work properly.

  12. Route the cable [A] along the right side of the scanner unit as shown below.

  13. Route the cable [A] along the rear side of the scanner unit.

    • Route the cable [A] behind the FFC [B].

  14. Remove the cutout [A] in the left rear cover to make a hole for the cable, and then pass the cable [B] through it.

  15. Connect the keyboard cable [A] to the USB slot.

  16. Reattach the removed covers.