1. Remove the machine from the box, and check the items in the package.

    • Remove the retainer [A] at the lower front right before lifting up the machine, because the handle for lifting the machine is hidden by the retainer [A].

    • When you lift the machine, hold the correct parts, as shown in the photo below. Do not lift by holding the scanner unit, etc., because this might deform the machine or break the exterior covers.

  2. Remove the tapes and retainers on the DF.
  3. Remove the tapes on the exterior of the copier.
  4. Remove the cushioning material [A] on the exposure glass.
  5. Remove the orange tape on the scanner shipping locks.

  6. Remove the two scanner shipping locks [A] by rotating them 90 degrees counterclockwise.
    SC120 is displayed when the machine is turned ON with the shipping lock attached.

    • Keep the scanner shipping locks after installing the machine. The scanner shipping locks must be installed before moving the machine to a new location.
    • Before moving the machine, make sure to move the scanner carriage to the correct position with SP4-806-001 (Super SP mode) and reattach the shipping locks (page 101 "Moving the Machine").

  7. Attach the two caps [A] provided with the machine.
  8. Pull out the 1st and 2nd paper feed trays and remove the tapes and accessories.
  9. Remove the scanner support [A].

  10. Open the front cover and store the scanner support [A] in the storage location.

    • The factory setting sheet is kept in the storage location.

  11. Close the front cover.