• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  • When attaching this 1-bin tray unit at the same time as the following peripherals, attach the one-bin tray first. Otherwise, the 1-bin tray’s exit tray cannot be attached.

    - Internal Shift Tray SH3070 (D691)

    - Side Tray Type M3 (D725)

    - Bridge Unit BU3070 (D685)

  • To use together with the “Internal Finisher SR3130” or “Internal Finisher SR3180”, first attach the bottom plate of Internal Finisher SR3130 and Internal Finisher SR3180, and then install the 1-bin tray.

  1. Remove the orange tape and shipping retainers.
  2. Remove the accessories (fixing screws, etc.) provided with the machine.

  3. Open the right cover, and remove the upper front cover.

    • When removing the upper front cover, release the hooks at the back of the cover.
    • Tilt the operation panel [B] upward to a horizontal position, and then remove the upper front cover [A].

  4. Remove the paper exit tray [A].

  5. Remove the paper exit feeler [A].
  6. Tuck in the lever [A] for detecting when the tray is full.
  7. Open the front cover, and then remove the upper left cover [A] by pulling it towards the front (×1).
  8. Release the hooks [A], and remove the left rear cover [B].
  9. Remove the inverter tray [A], and tray support rod cover [B] (×1).
  10. Remove the paper exit cover [A] (×1).
  11. Attach the gear [A] provided with the accessories.
  12. Attach the 1-bin tray unit [A].
    Make sure to engage it with the gear attached in the previous step.
    Take care that the harness is not trapped between the 1-bin tray unit and the machine frame.
  13. Attach the harness provided with the accessories.
  14. Attach the tray support bar [A] (×1).
    When attaching the tray support bar [A], make sure that the harness attached in the previous step goes through the slit in the tray support bar circled in blue [A] and comes outside of it as shown below.
  15. Hook the 1-bin tray [A] onto the 1-bin tray unit, aligning the positions in the blue circle.
  16. Connect the harness to the 1-bin tray, and bring it around.
  17. Insert the tray support bar firmly in the 1-bin tray, and attach the harness cover [A].
  18. Reattach the covers, and close the right door.
  19. Reattach the paper exit tray and paper exit feeler.
  20. Turn ON the main power.
  21. Check that output to this tray can be selected on the operation panel, and check the operation.