- Enter the SP mode.
- Output the SMC logging data with SP5-990-004.
Make sure to shut down and reboot the machine once before printing the SMC. Otherwise, the latest settings may not be collected when the SMC is printed. Set the following SPs (New Unit Detection) to "1".
Item
SP
Pressure Roller
- Replacement procedure: Pressure Roller
Fusing sleeve Belt Unit
Replacement procedure: Fusing Sleeve Belt Unit
If the entire fusing unit is replaced to a new one, the pressure roller and fusing sleeve unit are detected as new units without executing the new detection SP.
Pressure roller: SP3-701-118
Fusing sleeve belt unit: SP 3-701-116
Image Transfer Belt Unit
- Replacement procedure: Image Transfer Belt Unit
SP3-701-093
Image Transfer Belt Cleaning Unit
- Replacement procedure: Image Transfer Cleaning Unit
SP3-701-102
Paper Transfer Roller Unit
- Replacement procedure: Paper Transfer Roller Unit
SP3-701-109
Waste Toner Bottle
(When the bottle is replaced before the machine detects bottle full and stops)
- Replacement procedure:Waste Toner
SP3-701-142 Ozone Filter, Dust Filter
- Replacement procedure: Ozone filter/Dust filter
SP3-701-131
- Turn the main power switch OFF, and disconnect the power cord from the outlet.
- Replace the PM parts and turn the main power ON.
The machine will reset the PM counters automatically. - Exit the SP mode.