1. Remove the rear right cover [A] (coin screw x2).
  2. Remove the rear cover [A].
  3. Remove the rear lower cover [A].
  4. Attach the DHB (X 3).

  5. Connect the two harnesses between the DHB and the PSU.

    •  Use the black harnesses [A] and [B]. Red and white harnesses are not used for this machine.

  6. Connect the connector  to the DHB, to the harness already attached, and to the base frame for the optional paper feed unit.

    • This cable is only white for NA/EU/AA.

  7. Pull out trays 1 and 2 from the machine.
  8. Connect the connector of the heater to the main machine.
  9. Install the heater inside the machine (x 1).
  10. Reattach trays 1 and 2.

  11. To keep the anti-condensation heater constantly ON, set SP5-805-001 (Anti-Condensation Heater ON/OFF setting) to "1".