• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  • When you unpack or move this unit, do not hold the paper exit guide [A]. Doing so may damage the unit.

  • Before installing this option, install the following options first;
    1. Bridge Unit BU3070 (D685), or Internal Multi-fold Unit FD3000 (M482)
    2. LCIT PB3260 (M496), or Paper Feed Unit PB3240 (M494)

  1. Remove the orange tape on the exterior covers and remove the shipping retainers. Then remove the accessories in the package (fixing screws, etc.).
  2. Open the front cover, and remove the orange tapes and shipping retainers.
  3. Remove the plate [A] only when installing the punch unit.
    For details about the punch unit installation, refer to Punch Unit PU3060 (D706-00, -01, 02, -03).
  4. Attach the shift tray [A] (×1: M3x8).
  5. Attach the ground plate [A] (M3x6).
  6. Attach the relay guide plate [A] (M3x6).

  7. Attach the joint bracket [A] to the main machine (x4: M4x12).

    If the machine is equipped with the bridge unit, attach the joint bracket [A] together with the L type connecting bracket [B] of the bridge unit.


    If the machine is equipped with the internal multi-fold unit, attach the joint bracket [A] only.

    • Attach the screw so that the screw head is at the center of the mark.

  8. Clean the right side of the upper cover with a cloth moistened with alcohol, and then attach the cushion [A] to the finisher.
    • Make sure that the cushion is aligned with the rear-upper edge of the upper cover.

  9. If the internal multi-fold unit is installed, connect the finisher cable to the connector on the internal multi-fold unit.


    Make sure that the finisher’s 2 cables are not crossing each other before you connect the finisher.

  10. Remove the screw on the connection lever [A] and pull the lever.

  11. Connect the finisher to the main unit, and then push in the connection lever [A] to fasten it to the main unit.


  12. If the bridge unit is installed, connect the interface cable to the machine.


  13. Attach the tray holder (x2).
  14. Close the front cover of the finisher.
  15. Turn ON the main power.
  16. Deliver some A3/DLT paper to the proof tray and check if the vertical registration is correct according to the adjustment scale for A3/DLT paper (Troubleshooting for Finishing Options).
  17. Check that the finisher can be selected on the operation panel, and check the finisher’s operation.