• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  1. Unpack the attention light and the accessories (fixing screws, etc.) provided with this unit.
  2. Remove the connection cover [A].
    Insert a flat-headed screwdriver into the gap at the front and lift the cover.

  3. Remove the small cover [A].

  4. Open the right door.

  5. First, remove a screw. Then release the hooks on the inside of the front upper cover [A] by pulling the cover’s sides outward, and remove the front upper cover.

  6. Remove the right upper cover [A].
    When removing the right upper cover, pull it out in the direction of the blue arrow.

  7. Remove the top right cover [A].

     

  8. Remove the rear left cover [A] (coin screw x2).

  9. Remove the rear cover [A].

  10.  Remove the controller box cover [A].
     Red Circle: Remove, Blue Circle: Loosen

  11.  Remove the clamp [A] and grounding wire [B], and release the USB cable from the harness guide [C]. (This is to prevent the USB cable from being pulled when turning over the operation panel.)

  12.  Remove the operation panel upper cover [A].

  13.  Remove the screws and clamps securing the operation panel to the hinge.

  14.  Spread out the service mat [A] on top of the machine, detach the operation panel from the hinge, and then place the operation panel face down on the mat.

    Be sure the service mat remains spread out underneath the operation panel to protect the display.

  15.  Remove the rear center cover [A].

  16.  Connect the black 5-pin connector [B] to the operation panel connector [A].

  17.  Secure the harness with the clamp [A] and route the harness along the USB cable.

  18.  Reattach the rear center cover of the operation panel, and then reattach the operation panel.

  19.  Reattach the operation panel upper cover.

  20.  Reattach the USB cable, clamps, and ground wire.

  21.  Attach small clamps (provided with this unit) on the side of the cable guide

  22. Route the harness as shown.

  23. Connect the white 3-pin connector to CN576 [A] on the IPU.
  24. Pull out the white 5-pin connector of the harness routed in step 22.

  25. Reattach the covers in the following order: controller box cover, rear right cover, and rear cover.

  26.  Attach the bracket [A] (M3x8 round-head screws).

  27. Attach the large clamp (provided with this unit) on the bracket.

  28.  Connect the harness to the connector of the attention light.

  29.  Attach the attention light on the main machine (M3x8).

    Make sure the harness does not get caught when attaching the attention light.

  30.  Reattach the covers in the following order: top right cover, front upper cover, and small cover.