• When lifting the mailbox to unpack it, hold the parts circled in blue.

  • Be sure not to hold the unit’s upper central part, where the feeler [A] to detect when the paper tray is full is located.

  • Do not hold other parts. Doing so may damage the exterior cover or deform the frame.



 

  1. Attach the shoulder screw [A] (provided with this unit) to the base of the operation panel.
  2. Attach the support bracket [A] (M4x6).
    Use the bracket with “A” stamped on it.


  3. Attach the rear bracket [A] with shoulder screws (M4x6).



    Do not route the USB cable (indicated in yellow in the figure) under the support bracket [A] or under the interface harness [B]. Doing so may cause the cable to break.

  4. Attach the rear cover [A] provided with this unit (hook x 2).
  5. Attach the rear top cover [A] provided with this unit (M3x6, hook x 1).

  6. Place the mailbox on a flat surface.

    • Put the mailbox on a table so that the rear part [A] is over the edge. Be careful not to drop the mailbox.

  7. Remove the orange tapes.
  8. Open the right door and remove the indicated screw (M3x8).

  9.  Release the rear cover’s hooks [A] and [B], and then remove the rear cover by holding it at the top and pulling it.

  10.  Hold the areas shown by the blue circles, and mount the mailbox on the machine.

    When you mount the mail box, it is easier if you stand at the right side of the machine, facing the bypass tray.


  11. Slide the mailbox from left to right as viewed from the front.

    • Mount the bracket [A] on the support bracket [B] at the rear of the mailbox, and then slide it to align the screw holes.

    • Align the shoulder screw [C] with the positioning hole [D], and then slide it until it engages with the groove behind the hole.
    • Align the shoulder screw [E] with the positioning hole [F], and then slide it until it engages with the groove behind the hole.
    • Slide the mailbox plate [G] toward the stopper [H] on the machine’s mounting base until it stops.

  12. Attach the rear securing bracket [A] (hook x1).

  13. Attach the front securing bracket [A] (hook x1).

  14. At the rear side of the mailbox, fasten the joint [A] to the indented part of the support bracket [B] (M4x6 screw) as shown.

  15.  Connect the harness [A] to the relay connector on the machine, and insert the clamp attached to the harness into the hole [B] in the machine frame.
  16.  Insert the top right cover [A] (provided with this unit) beneath the mailbox, and secure it to the machine (M3x6).
  17.  Reattach the rear cover of the mailbox.

  18.  Attach the supplied inverter tray.

  19. Attach the four supplied paper exit trays.

  20.  Remove the canopy [A] of the front upper cover.

  21. Reattach the right upper cover, front upper cover, and small cover.

  22. Reattach the operation panel top cover.

     Make sure that the harness and USB cable are not caught when attaching the operation panel top cover.