To secure space for installing Mail Box CS3010, move the operation panel to the front. Also, pull out the USB cable connected to the operation panel as far as needed for the move.

  1. Remove the rear left cover [A] (coin screw × 2).

  2. Remove the rear cover [A].

  3. The orange harness is clamped but not connected. Release the clamp, connect the harness to the connector, and then tighten the clamp.

  4. Remove the clamps [A] and [B], and release the USB cable.

  5. Pull the USB cable in the direction of the blue arrow and attach the clamp [B] to the part between the 2 ties.

    If the cable is too stiff to attach the clamp [B], pull out the clamp [C] on the frame by pinching as shown by the red arrows.

  6. Disconnect the clamp [D] and the ground wire [E], and release the USB cable from the harness guide [F].

  7. Pull the USB cable out toward the operation panel side and secure sufficient length to move the operation panel.

  8. Reattach the rear cover [A] and then the rear left cover [B] (coin screw x2).

  9. Remove the operation panel upper cover [A].

  10. Remove the operation panel [A] from the machine while keeping the USB cable connected to the machine.

  11.  Place the operation panel [A] on the top rear cover with LCD facing down.
  12. Open the inverter guide cover [A], and remove the inverter guide cover and its exterior cover.
    Lift the exterior cover from the screw bosses [B], and then slide the inverter module in the direction of the blue arrow and remove it.
  13.  Disconnect the inverter guide cover sensor and remove the inverter guide [A].
  14.  Remove the inverter guide bracket [A].
  15.  Attach the operation panel more forward than before.
    [A]: Installed position: After moving
    [B]: Installed position: Before moving
    [C]: Adjust the tab at the base of the operation panel to the indicated position
    [D] Position of screw holes for operation panel securing brackets: After moving
    [E] Position of screw holes for operation panel securing brackets: Before moving


  16. After transferring the operation panel, attach the ground wire at the position [A].
    Fasten it with the screw removed at step 6.
  17.  Route the USB cable inside the 7 hooks on the harness guide.
  18.  Fasten the USB cable and the ground wire at the position [A] using the supplied clamp.