• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  1. Remove the rear upper cover [A] ( ×2)
  2. Remove the rear lower cover [A] ( ×2)
  3. Remove the plate [A].

  4. Remove the inner cover [A] ( ×3, ×1)

    • There is a connector on the back of the inner cover.

  5. Remove the punch guide plate [A].
  6. Attach the punch unit stay [A] (×4).

    [A]: Rear, [B]: Front

  7. Attach the punch waste paper guide [A] (×1).

    • After inserting the front tab of the punch waste paper guide into the frame [B] of the finisher, insert the rear tab into the frame [C].

  8. Attach the hopper bracket [A], inserting from the outside frame of the finisher. (×2, 2 hooks)

    • Hook the hooks of the hopper bracket [A] onto the back side of the frame.

    • Hook the upper frame of the hopper bracket onto the outside frame of the finisher.

  9. Fix the harness of the hopper sensor. ( ×1)
  10. Attach the registration guide plate [A]. ( ×2)

    [A]: Rear, [B]: Front

  11. Attach the side-to-side detection unit [A]. ( ×2)

    • Insert the front pins of the side-to-side detection unit into the holes of the frame.

  12. Attach the punch unit [A]. ( ×2)

    • After inserting the pins [B] of the punch unit stay into the front and rear holes of the punch unit, fix the punch unit with two screws.
    • Rear
    • Front

  13. Attach the punch unit movement motor unit [A]. ( ×2)

    • Engage the gear [B] of the punch unit movement motor unit with the rack [C] of the punch unit.

  14. Connect the harness of the hopper sensor to the connector of the finisher.
  15. Connect the harness of the punch unit to the connector of the registration drive unit.
  16. Connect the harness of the punch unit to the main board, and then clamp it. ( ×2, ×2)
  17. Connect the harness [B] of the punch unit movement motor unit and the harness [C] of the side-to-side detection unit to the punch unit board [A].
  18. Attach the supplied cover [A] to the punch unit board.
  19. Clamp all the harnesses of the punch unit PU3060. ( ×8)
  20. Attach the hopper [A].
  21. Attach the rear upper cover, the rear lower cover, the inner cover, and the punch guide plate.