When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

 

  1. Remove the small cover [A].

  2. Open the right door.

  3. First, remove a screw. Then release the hooks on the inside of the front upper cover [A] by pulling the cover’s sides outward, and remove the front upper cover.

  4. Remove the right upper cover [A].
    When removing the right upper cover, pull it out in the direction of the blue arrow.
  5. Remove the rear cover [A].

  6. Remove the cover [A] over the machine’s USB slot and pass the cable through.

  7. Make a single loop in the USB cable, and then attach the ferrite core [A]. 
  8. Connect the USB cable to the machine’s USB port.
    There are two USB ports. You can connect to either.
  9. Pass the USB cable from the back to the right side of the machine.
    Pass the cable behind the pillar [A].

  10. Clamp the cable at four points on the right side.
    Use the clamps supplied with this option.

  11.  Attach Bracket A [A] to the machine’s right frame (M3x8).

  12.  Thread holes on the removed right upper cover (3 points).

    • Using the supplied tapping screw (M5x13) [A], position the screw to the center part of the guide rib and thread each hole. After threading each hole, use a tool such as a screwdriver to enlarge the hole so that the fastening screw (M3x20) can go through it.


    • Be careful not to drop the shavings in the machine (do not leave shavings around the holes).

  13.  Reattach the covers in the following order: right upper cover [A], front upper cover [B], small cover.
     When attaching the right upper cover, pass the USB cable through the notch [C] on the right upper cover.
  14. Pass the USB cable through the groove on the cover.

  15. Attach the bracket for side table[A] on the right upper cover (M3x20).

  16.  Attach the lower cover [A] by having it engaged with the two tabs on Bracket A (M3x8).

  17.  Attach the upper cover [A] (M3x10).

  18.  Attach the reader spacer [B] to the reader holder [A].

    The IC card reader may be too thick to attach the reader cover. If this happens, it is not necessary to attach the spacer to the reader holder.


  19.  Attach the sponge cushions [A] on two points on the reader spacer as shown.

    If you do not attach the spacer cushions in Step 17, attach them to the reader holder.

  20.  Make a single loop in the USB cable, and then attach the ferrite core [A].
    Attach the ferrite core to the cable at the point 45 mm away from the cable end.
  21. Connect USB cable to the NFC reader.
  22.  Place the NFC reader [A] on the spacer [B], and then attach the reader cover [C].
     Be careful not to have the USB cable trapped between the cover.
  23.  Remove the release paper [A] at the back of the reader holder, and then secure the NFC reader on the table.
  24.   As required, use the stick-type clamp [A] to secure the USB cable.