1. Enter SP2-109-003.

  2. Print out the test pattern (14: 1-dot trimming pattern) with SP2-109-003.

    • Registration can change slightly as shown on the previous page. Print some pages of the 1-dot trimming pattern for steps 3 and 4. Then average the leading edge and side-to-side registration values, and adjust each SP mode.

  3. Do the leading edge registration adjustment.
    1) Check the leading edge registration and adjust it with SP1-001.
    2) Select the adjustment conditions (paper type and process line speed).
    3) Input the value. Then press [#].
    4) Generate a trim pattern to check the leading edge adjustment.
  4. Do the side-to-side registration adjustment.
    1) Check the side-to-side registration and adjust it with SP1-002.
    2) Select the adjustment conditions (paper feed station).
    3) Input the value. Then press [#].
    4) Generate a trim pattern to check the side-to-side registration adjustment.