1. Remove the scanner unit and the ADF. (Scanner Unit with the ADF)
  2. Attach the IC card reader [A] to the rear of the front right cover [B] with the bracket [C]. ( × 1 included in this kit)
  3. Route the USB cable [A] from the IC card reader as shown below, and then pull out the USB cable from the rear of the machine.
  4. Cut out the hole for the USB cable to pass through the scanner rear cover [A].
  5. Pass the USB cable from the IC card reader through the hole in the scanner rear cover, and then reassemble the machine.
  6. Do the following steps:
    • Attach the clamps [A] to prevent the cable from sagging.
    • Connect the USB cable to the USB connector at the left of the mainframe as shown below. Either connector can be used.

    • Obtain these clamps [A] in advance, because they are not included in this kit.