1. Remove the tapes and the retainers from the machine.

  2. Do the following steps:
    • Open the ADF cover [A].
    • Remove all the tapes and the retainer (protective paper) [B] from the exposure glass.
  3. Remove the sheet [A] inside the ADF.
  4. Remove the following items:
    • Paper tray [A]
    • Retainer [B]
  5. Open the front door [A].

  6. Pull out all protection seals [A] on the drums straight out towards the front.

    • Do not remove the orange tape [B] at this time.

  7. Remove the waste toner bottle [A].
  8. Remove the orange tape [A] attached to the lever.
  9. Set the lever [A] to the upright position.
  10. Attach the waste toner bottle.
  11. Shake each toner bottle [A] from eight to ten times.
  12. Install each toner bottle [A] in the machine.
  13. Close the front door.
  14. Connect the power cord to the machine.
  15. Attach the paper tray.
  16. Connect the network cable, if the client IP addresses are automatically provided through a system such as DHCP in the network settings. If a static IP address is provided to the client machines, contact the customer (network administrator) to determine the appropriate timing for connecting the network cable.
  17. Turn ON the main power.

  18. The machine starts the initial settings automatically.

    • A message “Turn the main power switch off then on” may appear during the initial settings. However, DO NOT switch off the main power until the machine finishes the initial settings and emits a beep sound. It takes about five minutes to finish the initial settings.