• Do not lift the machine together with one or more paper feed unit(s):
    If there is already a machine with one or more optional paper feed unit(s), be sure to disconnect the machine and paper feed unit(s), and lift them up separately when moving/transporting. Otherwise, the handle of the paper feed unit will break due to the mainframe’s weight, and it can cause an injury.

  • Turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.
  • Do the following procedure to prevent the harnesses from being damaged.
  • Check that harnesses are not damaged or pinched after installation.

  1. Attach the two locating pins [A] [B] on the table.

  2. Attach the heater bracket [A]. ( × 2)

    • Pass the connector through the hole in the table.

  3. Connect the heater harness [A] to the anti-condensation heater and route it as shown below. (× 1, × 3)

    • A: For the anti-condensation heater
    • B: For the junction harness
    • C: For the isolation cap (Not used)
    • D: Isolation cap
    • The connector [C] is not used. Put the connector into the opening.

  4. Put the mainframe on the table.
  5. Remove the rear cover. (Rear Cover)
  6. Remove the left cover. (Left Cover)
  7. Remove the PSU fan. (PSU Fan)

  8. Connect the connector to CN600 on the PSU and route the junction harness along the red dotted line in the photo. ( × 1)

    • A: Not used (For the drum heater: If installing the anti-condensation heater for the mainframe)
    • B: Not used
    • C: For the heater harness
    • D: For the PSU (CN600)
    • If the anti-condensation heater for mainframe is not going to be installed, put the connector [A] and the connector [B] into the area as shown below.

  9. Install the PSU fan.
  10. Connect the junction harness [A] to the heater harness and route the junction harness along the red dotted line in the photo.
  11. Reattach the rear cover.

  12. Attach the two securing brackets [A] [B] at the rear of the machine. ( × 5)

    • Use the screws which are holding the rear cover.

  13. Attach the securing bracket [A] at the left of the machine. ( × 2)
  14. Reattach the left cover.