1. The original is set face-down.
  2. When an original is set in the ID Card Feeder, the ID Card Set Sensor [A] is turned on by the actuator blocking the sensor, and then a pre-feeding operation is performed.
    The pre-feeding time can be set in SP mode (6-020-001). If pre-feed cannot be performed with the ID Card Set Sensor on (for example, if the ADF is opened while a user has set an ID card, or the user holds the ID card intentionally and it cannot be fed), JAM001 occurs after approximately 4 seconds.
    The leading edge of the original is aligned by feeding the original to the Pre-scanning Roller [B].

  3. When the [Start] key is pressed, the original at the Pre-scanning Roller is sent to the straight-through path.

    There is no skew correction.

  4. The original is scanned by the Original Front Side CIS [A].

    The carriage unit moves from the home position [B] to the DF scanning position, but as the sheet-through glass is installed at an angle, the carriage unit moves at an inclination along the glass surface.

  5. When copying both sides, the rear of the original is scanned by the Original Rear Side CIS [C] positioned directly after the Original Front Side CIS.

  6. The original is ejected from the original exit tray by the Post-scanning Roller [D] and the DF Exit Roller [E]