The system software DVD contains the system software and E-24B System Software Installer. To install system software using the LAN port on the E-24B, you need:

Either:

Two Ethernet cables and an isolated hub/switch

Cables must be 4-pair/8-wire, short-length Cat 5 (for 100BaseT) or Cat 5e (for 1000BaseT)

Or:

  • For 100BaseTX: One Category 5 or higher Ethernet cross-over cable (4-pin/8-wire, short-length)
  • For 1000BaseT: One Category 5e or higher Ethernet cross-over cable (4-pin/8-wire, short-length)

A Windows Vista/7/8/10 computer ("PC") with:

  • CD/DVD drive, built in or attached
  • Support for 100BaseTX or 1000BaseT

  • This procedure describes using one cross-over cable. Instead of using a cross-over cable, you may use two Ethernet cables and an isolated hub/switch. (Do not connect any other devices to the hub/switch. Do not put the hub/switch on the LAN. Do not use the hub’s optical port or uplink switch.)
  • If the print engine is 230V, use shielded network cables.