Lubrication for preventing noise and vibration and for extending life (indicated in red in the following diagram).
- Paper exit/pressure release motor gear: gear teeth (1 spot) located in area 0-10 mm from the tip of the shaft
- End surface of gear boss (1 spot)
- End surface of gear boss (1 spot)
- End surfaces of gear teeth (2 spots)
- Stud center (1 spot)
- Area 45 mm from the tip of the stud (1 spot)
Lubrication parts
- 4 gears (5 spots)
- Shaft (stud) (2 spots)
Lubrication amount
Maximum [A] and minimum [B]
Gears
Amount of grease on studs