1. Remove the proximity sensor left cover [A].
  2. Open the right door, and then remove the small cover [A].
  3. Open the front cover.

  4. Remove the proximity sensor cover [A].

    • Remember that there is a tab at the positions of the red arrows.
    • Rotate the operation panel [B] upward to a horizontal position, and then detach the proximity sensor cover [A].

  5. Remove the original upper cover [A]
  6. Attach the corner cover [A] provided with this option.
    Use the screws removed in the previous step.
  7. Remove the scanner right cover [A].
  8. Reattach the proximity sensor cover with corner cover [A] to the machine.

  9. Pass the USB cable [A] through the hole.

    • This cable is not included in this unit. The user may need to provide it.

  10. Attach the table [A].

    • There are three ribs on the back side of the table.

  11. Attach the sponges [A] with double-sided tape.

  12. Connect the cable [B] to the IC reader [A] and attach the reader to the table.

    • The USB cable should be turned as the following photo shows.

  13. Attach the IC card reader cover [A].
  14. Attach the three clamps (x3).
  15. Remove the cover to make the hole [A] to pass the cable through.
  16. Connect the USB connector to the USB interface of the controller.
  17. Route the cable as shown in the following photo (x1).
    Tuck in the excess length portion of the cable in the space over the controller box.
  18. Reattach the exterior covers.