• When installing this option, turn OFF the main power and unplug the power cord from the wall socket. If installing without turning OFF the main power, an electric shock or a malfunction may occur.

  1. Hold the key counter plate nuts [A] on the inside of the key counter bracket [B] and insert the key counter holder [C].
  2. Secure the key counter holder to the bracket (x2).
  3. Install the key counter cover [D] (x2).
  4. Open the right door.

  5. Right rear cover [A] (x4, among them, tapping screw x1)

    • When installing, insert the projections [A] in the holes [B], taking care not to trap the harness inside.

  6. Remove the rear cover [A].
  7. Remove the controller box cover [A].
    Red Circle: Remove / Blue Circle: Loosen
  8. Route the key counter’s cable inside the machine and clamp it.
  9. Connect the key counter’s cable to the 4-pin connector [A] on the machine.
  10. Attach the supplied clamps [A], and then route the cable as shown.
  11. Open the slit in the rear cover to put the cable through, and then attach the rear cover while putting the cable through.
  12. Connect the key counter and cable.
  13. Attach the key counter [A] to the machine’s rear right.
  14. Reinstall all the covers on the main machine.
  15. Peel off the double sided tape on the key counter bracket and attach the key counter to the scanner right cover.
  16. Reassemble the machine.