SC NO.

Pattern

Details (Symptom, Possible Cause, Troubleshooting Procedures)

195-00

D

S/N input error

Compare the product ID code of the product S/N (11 digits).

The product ID code of the product S/N (11 digits) does not match.

Re-enter the product S/N.

SC NO.

Pattern

Details (Symptom, Possible Cause, Troubleshooting Procedures)

230-01

230-02

230-03

230-04

D

FGATE*1: Does not turn ON.(01: Bk, 02: C, 03: M, 04: Y)

GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGATE assert time.

  • Control Board
  • Engine Board
  • Turn the power OFF and then ON.
  • Replace the Engine Board.
  • Replace the Controller Board.

(*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.

(*2)GPIO: A type of input/output terminal

SC NO.

Pattern

Details (Symptom, Possible Cause, Troubleshooting Procedures)

231-01

231-02

231-03

231-04

D

FGATE*1: Does not turn OFF.(01: Bk, 02: C, 03: M, 04: Y)

GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time.

* This is an I/O pin. Such I/O pins can be used for a variety of applications, depending on the setting.

  • Control Board
  • Engine Board
  • Turn the power OFF and then ON.
  • Replace the Engine Board.
  • Replace the Controller Board.

(*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.

(*2)GPIO: A type of input/output terminal

SC NO.

Pattern

Details (Symptom, Possible Cause, Troubleshooting Procedures)

270-00

D

Write ASIC communication error

  • When the Engine Board could not read the Unique ID of the Writing ASIC properly when starting this machine.
  • When an Error bit occurred in the communication between the Engine Board and the Writing ASIC.

The unique ID of the write ASIC was not read normally.

  • Turn the power OFF and then ON.
  • Replace the Engine Board.

SC NO.

Pattern

Details (Symptom, Possible Cause, Troubleshooting Procedures)

277-00

D

LEDA communication error: power supply system

The power supply to LEDA has been cut off due to a blown fuse or other problem.

Blown fuse

  • Check the FFC.
  • Turn the power OFF and then ON.
  • Replace the FFC.
  • Replace the Engine Board.

SC NO.

Pattern

Details (Symptom, Possible Cause, Troubleshooting Procedures)

277-01

277-02

277-03

277-04

D

LEDA communication error (01: Bk, 02: C, 03: M, 04: Y)

Communication between the LED head and engine board has failed.

  • LED Head error
  • Harness Error
  • Check the FFC.
  • Turn the power OFF and then ON.
  • Replace the FFC.
  • Replace the LED Head
  • Replace the Engine Board.
  • Return SP2-1205-020 to the initial value