On the TM (ID) sensor head part, there is a barcode label which shows the characteristics of the TM (ID) sensor. Before replacement, you must input these values into SP mode.

  • Before replacement, it is recommended that you output SMC all print in case process control/Music cannot complete correctly after replacement.

  1. Tear off the characteristic value data label supplied with the TM (ID) sensor along perforation [A]. (Leave the QR code [B] on the sensor.)


    • Viewed from the front of the machine, the sensor on the left is the TM (ID) sensor: R, and the sensor on the right is the TM (ID) sensor: L. Be careful about this during the following procedure.

    Barcode label values

    [A]: Characteristic Value

  2. Turn the machine switch ON and enter the SP mode.
  3. Then input the characteristic values in SP mode as follows.
    Input the values for TM sensor: R in SP3-333 and the values for TM sensor: L in SP3-334 as follows:

    SP No.

    Value

    3-333-001

    Value “1” written on the R sensor label (the sensor on the observer’s left)

    3-333-002

    Value “2” written on the R sensor label (the sensor on the observer’s left)

    3-333-003

    Value “3” written on the R sensor label (the sensor on the observer’s left)

    3-333-004

    Value “4” written on the R sensor label (the sensor on the observer’s left)

    3-333-005

    Value “5” written on the R sensor label (the sensor on the observer’s left)

    3-333-006

    Value “6” written on the R sensor label (the sensor on the observer’s left)

    3-334-001

    Value “1” written on the L sensor label (the sensor on the observer’s right)

    3-334-002

    Value “2” written on the L sensor label (the sensor on the observer’s right)

    3-334-003

    Value “3” written on the L sensor label (the sensor on the observer’s right)

    3-334-004

    Value “4” written on the L sensor label (the sensor on the observer’s right)

    3-334-005

    Value “5” written on the L sensor label (the sensor on the observer’s right)

    3-334-006

    Value “6” written on the L sensor label (the sensor on the observer’s right)

  4. Initialize the values of the sensitivity correction coefficient of the TM sensor.

    SP No.

    Default Value

    3-330-001

    0

    3-330-002

    0

    3-330-003

    0

    3-330-011

    1.2

    3-330-012

    1.2

    3-330-013

    1.2