1. Remove the lower left cover. (Lower Left Cover)
  2. Disconnect all 24 connectors and FFCs from the engine relay PCB (PCB21) (a).
  3. Remove three screws (a)(M3x8).
  4. Detach the engine relay PCB (PCB21) (b).
  5. Disconnect the connector (b) of the lift motor (M9) (a).
  6. Release the wire from ten hooks (c).
  7. Release four hooks (a).
  8. Remove the rear left duct (b).
  9. Release two hooks (a).
  10. Remove the lift motor (M9) (b).
  11. Check the paper feed drive unit and clean or replace it if necessary.

  12. Reattach the parts in the original position.

    • Apply one drop of grease (VSSG9005: MOLYKOTE EM-50L) on the gear surface when attaching the new lift motor (M9) (a).
    • Insert the boss (c) to the positioning hole (b) of the lift motor (M9) (a) and reattach it.

  13. Attach the lift motor (M9) (a) after confirming it is not run over the rib (b).