Alignment Brush Roller

Preparation

• Open the front door.

• Lower inner cover Rb10, Rb11 (Lower Inner Cover: Rb10, Rb11)

• Center inner cover Rb14, Rb16 (Center Inner Cover: Rb14, Rb16)

• Right panel (Upper, Lower Right Panels)

Rear

1. Remove gear [A].

2. Remove gear and bushing (x1, x1, Bushing x1)

   

Front

1. Remove the bushing [A] (x1).

   

2. Remove the alignment brush roller.

   

Re-installation

1. The end of the shaft with the flat bevel is the rear end of the shaft where the gear and belt must be re-attached.

   

2. When you re-install the brush roller [A], make sure that pawl [B] of the guide is below plate [C].