Preparation

  • Switch the system off.

  • Disconnect the finisher from its power source.

  • Wait at least 30 minutes.

  • Right panels (Upper, Lower Right Panels)

  • The PSU will retain residual charge, even after the machine has been turned off.
  • Allow at least 30 minutes for any residual charge to dissipate before you touch the PSU.

  1. The PSU is on the bottom right edge of the unit.

  2. Disconnect the board (x3,x5).

    • Be sure to re-connect the bayonet connectors at White above Black.

  3. At the rear [A] disconnect the fan (x1,x1).

  4. Disconnect the board bracket:

    [A] Rear (x3)

    [B] Front (x1)

  5. Remove the bracket (with board attached).

  6. Separate board and bracket (x5).