Stapler JG Motor

The stapler junction gate motor is behind the punch unit PCB.

Preparation

Remove:

• Rear upper (cover (Rear Upper Cover)

• Punch unit PCB (Punch Unit PCB)

1. Open the harness clamps of the motor [A] ( x3)

2. Disconnect the motor at [B] ( x1)

   

3. Remove motor bracket [A] ( x2)

   • Slowly, pull the bracket away.

   • Make sure the Teflon collar [B] does not fall off the end of the junction gate shaft. Remove it so that it does not accidentally slip off the end of the shaft.