Common procedures

  • Corner Stapler HP Sensor

  • Corner Stapler Rotation HP Sensor (Rear)

  • Corner Stapler Rotation HP Sensor (Front)

Preparation

  • Pull out the stack/staple unit with handle Rb12.

  • Remove corner stapler (Corner Stapling)

  1. Push the stapler to the rear [A].

  2. Remove the screw of the stapler guide rail [B] ( x1).

  3. Push the guide rail [C] to the rear and remove it.

  4. Remove spring [A].

  5. Loosen screw [B] (do not remove it).

  6. Rotate the plate down to relieve tension on the belt.

  7. Disconnect the belt at the front and back.

  8. Lift the stapler mount [A] off its rails and turn it toward the rear so you can see the back of the mount. The mount is on two steel rollers and that rest on the bottom rail of the corner stapler unit.

  9. Remove sensor bracket [A] ( x2).

    Three sensors are on this bracket:

    Rotation HP sensor (rear) ( x1, x5)

    Rotation HP sensor (front) ( x1, x5)

    Stapler HP sensor ( x1, x5)

Re-installation

  1. When you set the stapler mount on its rails, make sure that the belt [A] on the back of the stapler mount does not interfere with the two steel rollers.