Entrance Roller Motor

Preparation

• Rear upper cover (Rear Upper Cover)

• Rear lower cover (Rear Lower Cover)

• Right panels (Upper, Lower Right Panels)

1. The entrance roller motor is under the paper entrance guide.

   

2. A tension spring is attached to the motor bracket behind the main control board. The main control board mounting bracket must be removed in order to remove and re-attach this spring.

   

3. Disconnect the main board (x17, x44).

   

4. Disconnect the board bracket at the top [A] and upper left corner [B] (x2).

   

5. Disconnect the board bracket at lower left corner [A] and right edge of the board [B] (x2).

   

6. Remove the bracket with main board attached.

   

7. On the other side of the frame [A] disconnect the motor (x1).

8. On the front of the frame [B] remove spring (x1).

   

9. Disconnect belt [A] (x1).

10. Twist and push the bracket through frame [B].

    

11. Remove bracket (with motor attached) from under entrance guide.

    

12. Separate motor and bracket (x2).