1. Complete the procedure of "Preparation at the Customer Site". [Link To Preparation at the Customer Site]
  2. Remove all the USB devices that may be connected to the E-25C.
  3. Power on the Windows PC and do the following:
    • Start the Fiery Installer Builder. (Double-click the Fiery Installer Builder icon on the desktop. You can also click Start > EFI > Fiery Installer Builder)
    • Close all software applications except the Fiery Installer Builder.
    • Remove any network cables between the Windows PC and the customer network.
    • Disable all power-save and hibernation settings.
    • Stop all File Transfer Protocol (FTP) and Trivial File Transfer Protocol (TFTP) services.
    • Disable all anti-virus and anti-spyware programs.
    • Make sure that the PC is configured to obtain its IP address automatically (DHCP).
    • Disable all wireless network connections.
      • It is also recommended to disable the network adapter(s) on the client PC that will not be used for the connection to the E-25C in the following steps. (For the procedure on how to disable/enable the network adapter, refer to the Windows help.)
    • Turn off the Windows Firewall.
    • Remove all USB devices that may be connected to the E-25C.
  4. At the Downloaded window of the Fiery Installer Builder, select Color Controller E-25C 1.0.
  5. From the Preparation action list, select Perform Network installation.
  6. Read the instructions in the windows and click Next.
  7. Shut down the E-25C [Link To Shutting Down the E-25C Only].

  8. Remove all external cables from the E-25C, except the power cable. 

    Be sure to leave the power cable connected between the E-25C and the power outlet.

  9. Set the E-25C service switches to the service mode position: ON.

  10. Connect a cross-over network cable between the E-25C network port and LAN port on the Windows PC.

  11. Turn the main power switch of the E-25C to ON, then press and release the soft power push button on the front of the E-25C.
    Wait approximately 15 seconds for the E-25C to start up and show '00' on the diagnostic LEDs.

  12. In the Select a Network Adapter window of the Fiery Installer Builder, select the network connection that is corresponding to the network port that you attached the network cable to, then click Next. 

    A message appears that indicates that the installation has started. Once the installation is complete, the E-25C will shut down automatically.

  13. Set the service switches to the normal position (not ON).

  14. Disconnect the network cable from the E-25C network port and LAN port on the Windows PC.

  15. Return all the settings made on the PC in Step 1 and reconnect all cables that you removed earlier from the E-25C rear panel.

  16. Turn ON the copier main power switch.

  17. Turn the main power switch on the E-25C rear panel to ON.

  18. Press and release the soft power push button on the front panel of the E-25C.

  19. Wait for 10-15 minutes. When the diagnostic LEDs remain at '00', go to the copier operation panel and press the Home button.

    During the 10-15 minutes, the diagnostic LED may remain displaying 'FF' for several times, but this does not indicate an error.

  20. Touch the Fiery icon. "Please Wait!" may appear on the copier operation panel for a while.
    Within a few minutes, the language selection screen appears. If it does not appear, press the Home button on the operation panel of the copier and touch the Fiery icon again.

  21. Continue the initial setup. For details, see [Link to After Installing or Updating the System Software]